Olly Writes

Woodwork, writing, walks, DIY and more!

Tag Archives: weight

New Safety Boots

At the end of March, I started a new job and I recently treated myself to a new pair of safety boots. It’s been slightly surreal, doing a similar job to my previous one but working in a different environment, after almost six years with one company.

Change isn’t always a bad thing, as much as we may sometimes fear it.

Read more of this post

Advertisements

What’s in my Backpack? (Winter Hiking – Osprey Manta AG 28)

How much and how many items do you carry in your backpack,

when preparing for a day of hiking?

I’ve seen other YouTubers release ‘What’s in my pack?’-style videos and have decided to create one of my own, centred around winter hill walks and hiking. I also thought this kind of upload might be good for my still-new-but-slowly-growing channel.

It’s also an opportunity to highlight a few features of the Osprey Manta AG 28 backpack that I purchased in June, without doing a run-of-the-mill review-style video.

Audio isn’t great and my camera is partly to blame (hoping to upgrade/replace that, later this year) and I perhaps made the mistake of trying to hide or disguise the camera noise with music… Some will like it; some won’t. In hindsight, I could’ve recorded the audio on my phone and worked through painfully synchronising it with the video footage. But for the weather outside, I could’ve also recorded it in a more appealing location than my own bedroom.

I hope that people find it interesting. Constructive feedback is always welcome. I also aim to release a similar video over the summer so that we (and I) can compare. I’ve also started to create my own thumbnail images to accompany my videos.

Disclaimer: I live in North Somerset and mostly walk ten-to-twelve miles at a time, during winter. Most conditions and landscapes, except for mountains. My arrangements may not suit everyone.

Link to my channel: Olly Outdoors

Thanks for watching and reading.

Getting a Grip

It must have been late-2009 when I made a plywood base cabinet to sit directly underneath my chip extractor (an Axminster ADE1200). Small workshops are all about making the most of whatever space you can find. As this extractor wasn’t very tall (no more than 5ft, to the top of the filter bag), I seized on the opportunity to increase its height by a good foot and to keep some of my ‘junk’ from off of the floor.

This extractor lives in a corner of the workshop, which makes it very difficult to access directly, when the time comes to change the bag. So, it’s often easiest for me to clear a space ahead and to roll the unit forwards. A problem occurs then because the weight of the unit is still on top, with the motor and so, attempting to drag of push the extractor out of or in to hiding often results in it tipping up. That’s why I decided to finally make and fit another handle lower down, which would allow me more direct control over the ‘weight-less’ half of the unit, directly supporting the upper load.

Read more of this post

%d bloggers like this: