Olly Writes

Woodwork, writing, walks, DIY and more!

Tag Archives: through

Drawer Construction

There are several different ways to construction a traditional drawer, which most commonly involves cutting hand-dovetail joints; usually single-lap or “half-blind” dovetails where the sides meet the front, with through dovetails at the back – although, I’ve also seen people use a sliding dovetail housing, for the rear joint. While this joints offer strength beyond the sole reliance on the adhesive used, they are time-consuming to cut and, if you’re working to a commission, it’s very difficult – if not impossible – to cut the cost down on a large chest of drawers, for example. Even with a time-saving router jig; unless you buy the very best, you’re going to end up limited to cutting pins and tails of equal width – just as you might find in a mass-produced piece of furniture! 😛

So, I’d like to take a little time to talk about drawer construction and to share with you this method of “efficient” joint design that I’ve recently come up with…

Read more of this post

Sliding Towards the Finish

While I haven’t had much time on the bookshelf since Monday, I did manage to get all the sliding dovetail housings cut for the shelves on Tuesday afternoon. Then, yesterday, in the evening, I made some attempts toward sanding all internal faces and applying the first coats of finish…

Read more.

%d bloggers like this: