Olly Writes

Woodwork, writing, walks, DIY and more!

Tag Archives: suspended floor

DIYing for Friends

I recently made reference to the fact that I spent a weekend working at a friend’s house in early October. This largely involved sanding the wooden floors in two rooms and attending to the near-disastrous state of alcove shelving in the living room (some people should be banned from owning hand saws).

Let’s start by looking at the big job: sanding. Lots of sanding. Then again, downstairs.

Read more of this post

Advertisements

Nogging Along

In order to strengthen any floor; to prevent the joists from moving and also to reduce any risk of the floor sagging, it’s important to add at least one series of noggings (note the third, silent G!). In many cases, as with my floor, only one set of noggings down the centreline of the new floor is required. Where a floor covers a greater span though, it may be required that you have an additional two lines of noggings.

Read more of this post

Hanging Out

With the 7x2in joists all cut to length, ends re-sealed and ready to fall in to place, my next job was to set out the positioning and spacings for each of the sixteen hangers (eight on either side) and then, to fit them in to place. Below, you can see a mock-up of what I needed to achieve, where the joist must sit 32mm (1¼in) higher than the wall plates, in order to clear the existing truss-frame by a good 5mm, which had already begun to deflect where I’ve previously used it, in appropriately, to store goods (it’s only 4in/100mm deep and is riddled with woodworm, you see).

Read more of this post

%d bloggers like this: