Olly Writes

Woodwork, writing, walks, DIY and more!

Tag Archives: sliding compound mitre saw

Picture Frame and Mitres

My next video on YouTube should document the making of a small picture frame made from a minute quantity of English walnut. Today, I’m going to share with you a bit about making the mitres on each of the four corners, as I took an opportunity to try and saw blade I’d not tested before and I’d like to share some of my thoughts on that.

Mitre Cutting Time!

I also decided to make a mitre-cutting jig for my mitre saw and there will be a shorter video showing how I made that, to be uploaded within days of the picture frame project going live.

Read more of this post

Advertisements

Tee-Halving Joint

At work today, I spent a lot of time thinking about how I haven’t done a video for over one month now; how much I want to make the most of what time I have left in my workshop; how I need to crack on and finish the mobile base I started for my table saw, weeks ago… All whilst banging nail after nail in to small sheets of wavy birch plywood!

So, I was home by 17.00 and, after briefly stopping in the bathroom, I grabbed my camera and headed straight out to the workshop! Evenings have been almost mild this week (even though forecasters are now forewarning the threat of snow to follow this weekend – just when we were opening our arms to welcome the spring!). In two hours, I managed to get the following filmed and also, I made some good progress on the mobile base, which I’ll share with you another time.

This is something that I originally intended to film and publish about a month ago during Get Woodworking Week… I also have a ‘Valentine’s Gift’ idea that I’d like to film at some point but, it looks like I’m going to sail straight past Mother’s Day with that one as well! This video’s all about cutting a tee-halving joint, which is a traditional form of lap-joint, between two pieces at 90°.

I hope you enjoy the video. I’m incredibly nervous and fast-talking infront of the camera but I welcome all and any comments people may have. It takes a good hour for me to upload a video of this length and I do now try to keep them brief… That also means compromising a little on the finished quality but then, I’m only using Windows Movie Maker, which is a free program.

If I was to use something paid-for (like Camtasia), would I able to experience faster upload speeds?

Ideally, I’d like to have one short video to upload once each week. In fact, from the video I’m sharing with you this evening, I could easily have cut a section from the end and published that under its own heading.

Thanks both for reading and for watching!

Picket Planters (Part 2)

Part 2 is my Picket Planters video series is now online. It starts off with more machining and ends with all the mortises having been cut on my benchtop, cast-iron hollow chisel mortiser.

In Part 3, I’ll begin by round-topping all the pickets and posts on the bandsaw and, after that, I’ll looking at cutting the tenons on the ends of each rail.

Thanks for viewing.

Sheet Material Storage Rack

Last week, I officially moved in to my new home [away from the workshop!] – and that’s no April Fools joke! All this moving around and finishing off all the niggling jobs around the house that weren’t completed have left me with the bare minimal of time to spend back at my ‘real‘ home, in the workshop. Before all this chaos started though, I did at least manage to knock together a simple storage rack for sheet materials, with a few spare hours spread out across one weekend. Yes, the workshop improvements are very much still on-going!

Read more of this post

%d bloggers like this: