Olly Writes

Woodwork, writing, walks, DIY and more!

Tag Archives: PVC

New Windows

When I moved to this flat in November 2013, I quickly began to compile a growing list of items that may need attention. Many of these have since been rectified, I am pleased to say. Some of which has been attended to by my own two hands. One area I was unprepared to tackle personally was the repair or replacement of the rotting windows.

1off

Single-glazed and long overdue a fresh coat of paint, to say the very least… Well, it was just over a year ago that my landlord (without any prompting from me, whatsoever) signalled an intention to replace all three windows, as they were beyond the best. This week, I’m pleased to be able to write that the have finally been removed.

Read more of this post

Advertisements

Making Hoses Fit

If you’ve ever tried to connect a vacuum to your portable power tools, you’re likely to have come across one (if not several) where the supplied nozzle at the end of the hose doesn’t even come close to fitting snugly in to the tool’s outlet. Some people will resort to using masking tape or scraps of PVC pipe; worse still (and I’ve been guilty of this many times) is where people decide to neglect the use of dust extraction and then proceed to cut, plane, rout or sand away with fine particles filling their workshops!

20131018_181954

On Friday, while I was waiting for the glue to dry on a pair of chess boards (more on the perils of gluing end-grain to end-grain another time), I decided to have a go at making an attachment that would connect my vacuum to my random orbital sander. As you can see above; it works and I got the idea initially from (I think) Chris Pine over on Keek (@cpine).

20131018_172645

An additional tip for drilling small squares safely!

You basically take two small squares of plywood, drilling one hole in each. In one block, you have a hole sized to take the nozzle from the vacuum; the other is drilled to fit over your tool’s outlet or port. Then, these two blocks are carefully glued together and I rounded the corners off to make it aesthetically pleasing.

It’s a custom solution that doesn’t cost a lot but might ensure you never run out of masking tape. You may still need to manufacture one ‘fitting’ for each of your tools but, if it means you’re more likely to use dust extraction then it’s worth it.

Thanks for reading and I hope you’ve found this tip useful.

%d bloggers like this: