Olly Writes

Woodwork, writing, walks, DIY and more!

Tag Archives: idigbo

Bench Repair (Part 3)

Having cut and cleaned out all the mortises in my previous session working on this bench, my next job was to cut the tenons on each end of the seven slats. With relatively small components like this, I like to use my faithful router sled to gauge the thickness by making a single pass across each face.

Read more of this post

Bench Repair (Part 2)

Over the weekend, I made further progress on the bench seat repair and started by preparing all my previously sawn stock down to finished dimensions.

When I’m working with timber that’s been at least partially sawn on a circular saw, which leaves a much cleaner finish than most bandsaw blades, I find it helpful to scribble over the sawn faces to void confusion later. Unless your planer knives are razor-sharp, it can sometimes be tricky to distinguish the prepared face and edge from the two other surfaces… On a few occasions, yes, I have made the mistake of referencing off the wrong face and edges when feeding stock through a thicknesser! 😳

Read more of this post

%d bloggers like this: