Olly Writes

Woodwork, writing, walks, DIY and more!

Tag Archives: HVLP

Dust Wrong

Last week, I found some time to tinker and experiment with the dust extraction setup for my bandsaw. For the last few years, I’ve been using a setup that allows you to connect a vacuum hose to an angled port that surround the blade just below the table. It’s often worked well, collecting a majority of the sawdust and also leaving less to settle on the lower blade guides.

20131015_192854

But it’s not always been as effective as it used to be and I think the change occurred once I added a simple dust separator in to the system, which has always been the Triton DCA300 Dust Bucket. Don’t get me wrong; I’m sure that another separator (particularly a cyclone) would give better results but the Triton one seems to offer an airflow that’s greatly reduced from the force drawn in by the vacuum on its own.

Read more of this post

Dust Extraction Tips

My latest YouTube video offers a couple of simple tips on using and maintaining your dust extractors that could help to maintain and restore your airflow. If you’ve suffered a loss of or drop in suction from either a twin-bag HVLP chip collector or, perhaps even a smaller HPLV vacuum-type; these tricks could really help you out.

One tip near the beginning offers an easier way to reattach the bottom bag without a second pair of hands. Also, you get to see how convenient it isn’t to access each of my extractors in a small workshop! 😉

I run an Axminster ADE1200 for collecting larger shavings and a Nilfisk-Alto Aero 25-21 for finer dust, which is partially filtered through a Triton DCA300 Dust Bucket.

Thank you and enjoy. 🙂

%d bloggers like this: