Olly Writes

Woodwork, writing, walks, DIY and more!

Tag Archives: broken

Cramps and Pains

With all the glue-ups I’m having to complete with for each of these cutting boards, it’s got me thinking about the sash cramps I own; which ones I like and which ones I actually needs.

In this post, I’ll be running through my ‘collection’ and attempting to construct a plan of action.

Read more of this post

I’d Rather Have Snow…

Just as I was getting dressed and ready to leave the house for work this morning, there was a knock on my bedroom door. Mum was eager to tell me that another fence panel had blown down overnight; narrowly missing her car and lying obtrusively on the drive. It wasn’t the panel I ‘repaired’ over the weekend – as I said then; that one’s never going to come out!! This one is as tall as it is wide.

A new day and another panel falls to the ground!

These photos were taken in the daylight, after I arrived home from work a couple of hours ago, using my phone as well (8 megapixels, apparently… Although, I rarely bother to preset the white balance). All I did in the darkness was to pick up all the loose stuff and to dump it infront of the workshop.

Read more of this post

Bench Repair (Part 4)

With the seat assembled and the bulk of the work on this repair job complete (ignoring the other seat, which suffered a similar fate to the first one, very recently), the last step before finishing was to create two new rails that would allow me to attach this new seat to the legs of the existing frame.

I didn’t have enough meranti left to do this but, I did have some iroko which is, in all fairness, likely to outlast the rest of the entire bench structure, if left untreated over the next few years! I used one of the original rails as a template to directly mark all the significant features on to the new wood (length, hole locations, mortise positions and the radiused ends).

Read more of this post

Bench Repair (Part 3)

Having cut and cleaned out all the mortises in my previous session working on this bench, my next job was to cut the tenons on each end of the seven slats. With relatively small components like this, I like to use my faithful router sled to gauge the thickness by making a single pass across each face.

Read more of this post

Drawer Repair

Shortly after moving home at the end of last month/beginning of this one, I was asked to repair a drawer for someone. Sadly, it wasn’t of the traditional all-wooden construction. But, with a thin sheet of paper containing an image of the Queen being waved in my face, I said I’d have a look at this chipboard conundrum.

Read more of this post

%d bloggers like this: